![]() ![]() > requesting target halt and executing a soft reset > MMU: enabled, D-Cache: enabled, I-Cache: enabled > target halted in Thumb state due to debug-request, My u-boot has the watchdog killed right away, so that's why it did not run. > With both files there was no reboot after the 30sĪh. I've seen a bricked NSA325 board behaves similarly, but the watchdog still kicks in at 30s. ![]() > Exactly the same behaviour with an uBoot-file from > completely, then a single cryptic character > Kwboot is possible, Bodhi`s uboot was sent > Serial console shows no sign of life, the system How can i bring the watchdog to a hold-state ?Įdited 4 time(s). Timed out while waiting for target haltedįailed writing file uboot.kwb to NAND flash 0 at offset 0x00000000 > nand write 0 uboot.kwb 0 oob_softecc_kw MMU: enabled, D-Cache: enabled, I-Cache: enabled Target halted in Thumb state due to debug-request, current mode: Supervisor With both files there was no reboot after the 30s however. Kwboot is possible, Bodhi`s uboot was sent completely, then a single cryptic character returned, nothing further happened.Įxactly the same behaviour with an uBoot-file from ArchLinux too. Serial console shows no sign of life, the system seems to reboot after around 30 s. Now I`m trying to reflash a used Zyxel NSA 325V1, bought on ebay. Last edit at 03:57AM by joerg_999.Īt first: i was able to reflash an iomega iconnect with this method in the last summer. # JTAG connector - Dockstar, GoflexNet, GoflexHome #ĭockstar plug J1 10 pin, Serial Link / JTAG (Pin counting pairwise, and original)įunction.name pin org pin name function color RS232 You also have to use the fitting uboot files for dockstar, envs are the same. Yes, should also work on a dockstar but you´ve to use dockstar.cfg from member z3bram3n some posts above. MMU: disabled, D-Cache: disabled, I-Cache: disabledĮrror: unknown NAND flash device found, manufacturer id: 0x10 device id: 0x10Įrror: unknown NAND flash device found, manufacturer id: 0x50 device id: 0x50 Target halted in ARM state due to debug-request, current mode: Supervisor Requesting target halt and executing a soft reset Info : accepting 'telnet' connection on tcp/4444 Info : feroceon.cpu: hardware has 1 breakpoint/watchpoint unit Info : JTAG tap: feroceon.cpu tap/device found: 0x20a023d3 (mfg: 0x1e9, part: 0x0a02, ver: 0x2) Info : This adapter doesn't support configurable speed Info : JTAG only mode enabled (specify swclk and swdio gpio to add SWD mode) Warn : use 'feroceon.cpu' as target identifier, not '0' Trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain connect_deassert_srst Info : auto-selecting first available session transport "jtag". SysfsGPIO nums: tck = 11, tms = 25, tdi = 10, tdo = 9 Need more retry?Ĭan I sure perfect wiring between RP2 and Pogoplug E2? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |